Chevrolet Traverse 1st Gen (2009–2017): Clunking Noise Causes, Troubleshooting & Repair Costs

1. Diagnostic Overview for Chevrolet Traverse 1st Gen (2009–2017)

When a Chevrolet Traverse 1st Gen (2009–2017) develops a clunking noise, it frequently signals broken front strut top mounts, torn lower control arm compliance bushings, or excessive driveshaft universal joint backlash.

Platform-Specific Advisory: On this vehicle, pay specific mechanical attention to 3.6 LLT timing chain stretch DTC P0008 and 6T75 transmission 3-5-reverse wave plate failure. Addressing the acoustic symptom early prevents cascading failures in neighboring engine or chassis subsystems.

2. Step-by-Step DIY Mechanical Inspection Checklist

Before taking your Chevrolet Traverse 1st Gen (2009–2017) to a garage, perform these visual and physical checks safely:

• Have an assistant bounce vehicle front end while holding top strut mount nut to feel for mechanical play.
• Visually inspect control arm rear rubber bushings for deep rubber splits, tears, or oil contamination.
• Shift transmission firmly between Drive and Reverse; a metallic clunk indicates driveshaft U-joint or motor mount slop.
• Check subframe mounting bolts and front sway bar D-bushings for ovaled wear.

3. Estimated Repair Costs & Part Replacements

Standard workshop repairs for a clunking noise on a Chevrolet Traverse 1st Gen (2009–2017) typically fall in the range of $110 – $590.

Pricing varies based on genuine OEM vs. aftermarket component selection, mechanic labor rates, and whether related hardware (such as mounting bolts, seals, or tensioners) requires simultaneous renewal.